Home › CAN / CAN-FD Internship

Automotive Communication & Safety

CAN / CAN-FD Internship

A CAN/CAN-FD communication and safety internship on the STM32 NUCLEO-G474RE. You'll build a deterministic embedded-C kernel, wire and diagnose a real two-node CAN-FD physical layer, work through frame arbitration and fault confinement, calculate valid FDCAN bit timing, design a protected signal-encoding scheme, and implement a receiver-side safe-state machine that rejects invalid traffic.

Who it's for

Open to B.Tech, M.Tech and diploma students and working engineers (ECE, EEE, CSE, E&I). Needs basic C.

₹48,000₹35,000 / 4-6 months

Included: Remote Hardware Lab worth ₹16,800 — 45 days of access to 13 automotive ECU projects on real STM32 boards and a real CAN bus.

What you'll get

Welcome to the CAN / CAN-FD Internship — CAN/CAN-FD Communication & Safety on the STM32 NUCLEO-G474RE. Watch the intro, then work through the modules and projects below.

11 modules — video lessons + real hardware lab

  1. Module 0 · Introduction to STM32 software and hardware — Orientation videos: toolchain setup, board overview and how this course works. No coding challenge — add one or more videos below.
  2. C1: C Values, Functions and Checked Arithmetic
  3. C2: Bits, Arrays, Pointers and Structures
  4. C3: State, Scope and Reproducible Debugging
  5. BF: CAN Foundation Bridge — Bytes and Rollover
  6. B1: Embedded C Kernel and ECU Architecture — Execute a deterministic cyclic task and prove deadline handling.
  7. B2: CAN/CAN-FD Physical Layer and Two-Node Rig — Wire two valid CAN-FD nodes and diagnose termination and standby faults.
  8. B3: CAN Frame, Arbitration, CRC and Fault Confinement — Predict the arbitration winner and explain ACK, CRC, stuffing and error states.
  9. B4: FDCAN Timing and CAN-FD Phases — Calculate a valid nominal bit rate and sample point before configuring STM32 FDCAN.
  10. B5: Signal Encoding, Counters, CRC and Scheduling — Pack physical values into a stable interface and detect stale or corrupted data.
  11. B6: Receiver Validation and Safe-State Machine — Reject invalid frames, qualify faults and command deterministic degraded/safe outputs.

4 hands-on projects

P1 · Deterministic Cyclic Kernel

Build a fixed-period task scheduler in embedded C on the STM32 NUCLEO-G474RE, detect deadline overruns and log timing evidence.

Submit: Source + timing log

P2 · Two-Node CAN-FD Link and Fault Diagnosis

Bring up a two-node CAN-FD link (NUCLEO-G474RE + MCP2562FD) and diagnose termination, standby and error-state faults from the bus behaviour.

Submit: Firmware + bus log + fault report

P3 · FDCAN Bit Timing and Protected Signals

Calculate a valid nominal bit rate and sample point, configure STM32 FDCAN, then pack physical signals with alive counters and CRC and detect stale or corrupted frames.

Submit: Timing calculation + firmware + CAN trace

P4 · Capstone — Safe-State CAN-FD Receiver ECU

Integrate the track into a receiver ECU that validates every frame, qualifies faults and commands deterministic degraded and safe-state outputs.

Submit: Source + test evidence + report

Try a free workshop first · Why CAEE · Remote Hardware Lab